How to Cut Down a Tree with a Chainsaw

Cutting down a tree, chiefly with a chain saw, is no small job & can be seriously risky. It needs setting up & accuracy. We need to know how appropriately get ready for tree-cutting plan & how to make cuts that will establish the route the tree will fall.

How to Cut Down a Tree

Size up the tree, which is going to cut. If the tree is wider than the bar, we ought not to cut the tree down expect experts assist. Glance for all the hindrance that can be in the way of the tree since it falls. Regard as the position of the tree & if it will be practicable to cut down the tree in the course, you desire. Look for & make preparation all probable run off routes.

Review the tree branches. More brushwood on one side will have an effect on how the tree falls. Look for something that can modify the heaviness allocation. Come across at all of the branches vigilantly. Movable branches might drop during the cutting procedure & can cause brutal wound or even death.

chainsaw does not cut very well

Map to cut the tree in the route of any lean. Cutting to cut down a tree next to lean needs elevated skills. Clear out the area in the region of the tree for fine footing.

Plan & easy escape routes at a 45-degree angle away from the fall. Ensure you will not slip in escape routes. You never want to run directly back, as the tree might put the boot in back off the stump.

Plan to get absent as fast as possible. Make a lodge cut. This cut must be made on the side & way the tree will fall. At concerning a 60- to 70-degree angle, cut a lodge that goes no more than a third of the way from side to side the width of the stem. The base of the lodge should be even.

Make a cut behind the lodge cut. Make the saw flat with 1 or 2 inch above the notch. Make a similar cut & cut swiftly and effortlessly besides cutting all the way from end to end the tree. Depart a ½ to an inch between the cuts.

Cutting with chainsaw

As early as you have the sense of hearing the tree start to fall, discontinue cutting right away. Turn off the saw & get away fast. Do not turn roughly to watch the tree fall. Ensure you are securely far away ahead of looking back.

Cutting Down Trees Too Close to a House

Trees that are rising too close up to the home can root plumbing damage or rub the outside walls. Removing these trees needs making suitable cuts.

Stop a tragedy by taking the fitting steps & making the exact cuts, so that tree falls in a confined area.

Things You’ll Need

  • Pruning saw
  • Ladder
  • Rope
  • Chain saw
  • Settle on the height of the tree. Take away any obstacles, as cars, container plants, from the region. Make sure the lean of the tree to facilitate you resolve the route of its falling.
  • Cut the top side branches to trim down the probable smash up it can cause if it falls the mistaken way.
  • Make use of a ladder & have a friend hold up the underneath as you cut the pinnacle branches with a pruning saw.
  • Cut off any thickly rising branches just about the base of the tree to provide right of entry to the trunk.
  • Cover a pull line around the top of the tree to pull it in the right direction. Tie a piece of rope at the top of the tree.
  • With a chainsaw, make a V-shaped notch on the side where you would like the tree to fall.
  • Initially, ensure your cut is corresponding to the ground. Make one one-sided cut above this cut and one partial cut below, creating a notch with a 90-degree gap.
  • Make your back cut from the back of the notch cut. Cut somewhat above the point of the notch cut. Call a friend drag on the line when you are doing this to provide the tree way to fall away from house safely.
Brian Berkowitz

Brian Berkowitz is the Editor of Who is a Power Tools enthusiast and love to share what he know about this field. In personal life, he is a father of two cute kid and loving husband of a beautiful wife.

Click Here to Leave a Comment Below 0 comments

Leave a Reply: